The design, build
and test of a 2 axis - 2 point traversing system was initially for the Aero.
Lab. UTM. The motor and controller used are of Velmex
and Vexta. With ball screw pitch of 1.6mm, the
accuracy provided by Vexta PK266 series (1.8 degree/step)
is less than 0.1mm. The control uses either LabView
or Matlab. The traverse is design by our fluid mechanics team and built at
our workshop. |
|
General arrangement drawing for the traverse |
|
This traverse system in front of UTM’s wind tunnel |
[back] |