The Malaysian Journal of Analytical Sciences Vol 12 No 2 (2008): 375 – 379

 

 

 

ANALYSIS OF TRACE ELEMENTS IN POWER PLANT AND INDUSTRIAL INCINERATOR FLY ASHES BY INSTRUMENTAL NEUTRON ACTIVATION ANALYSIS (INAA)

 

Wadeeah M. Al-Areqi*,  Amran Ab. Majid,  and Sukiman Sarmani

 

Programme of Nuclear Science, School of Chemical Sciences & Food Technology,

Faculty of Science and Technology, Universiti Kebangsaan Malaysia,

43600 Bangi, Selangor

 

*Corresponding author: walareqi@yahoo.com

 

Abstract

An elemental analysis of fly ash samples from Selangor & Perak coal-fired power plants and an industrial incinerator from Negeri Sembilan were carried out using instrumental neutron activation analysis (INAA). All samples were irradiated at the Malaysian Nuclear Agency laboratory PUSPATI Reactor for 6 hours and later counted at the Nuclear Science Program, UKM using an HPGe detector with a relative efficiency of 10% and resolution of 1.8 KeV (FWHM) at 1.33 MeV. International Atomic Energy Agency (IAEA) coal fly ash 1633a reference material (SRM) was used as a standard for quantitative analysis. A total of 11 elements (i.e. As, Ba, Ca, Ce, Cr, Co, Fe, Hf, Sc, Th and U) were determined in all three types of fly ashes. The concentration range of environmentally concern elements, As and Cr in the Selangor coal-fired power plant samples are 11.17 - 23.24 and 160.28 - 867.97 μg.g-1 respectively. The concentration range of radioactive elements U and Th are 4.79 - 10.29 and 14.6 - 61.29 μg.g-1 respectively, and the concentration range of Co, Hf, Fe, Sc, Ba, Ce, Ca are 11.88-83.61, 3.24 - 10.48, 30338 - 53885, 16.62 - 28.48, 178.97 - 8491, 127.41 - 217.2 and 10447 -20647 μg.g-1 respectively. The concentration range of As, Cr, U, Th in  the Perak samples were found to be 22.16 - 48.38, 44.37 - 74.78, 4.18 - 6.85, 8.71 - 11.43 μg.g-1 respectively, whereas  the concentration range of Co, Fe, Sc, Ba, Ce and Ca are 23.21 -29.66, 54621 - 71099, 30.9 - 31.77, 100.34 - 116.61 and 11533 - 16423 μg.g-1 respectively.  Differences exist in the elemental concentrations of both power plant fly ash samples due to the different feed coal and combustion temperature used. The concentration of Cr, Th and Ce in the Selangor fly ash samples was generally higher compared to the samples obtained from the Perak power plant. This study also shows that only As and Ca were detected in the Negeri Sembilan samples with the concentration ranging from 36.66 - 98.67 and 31709.10 – 45606 μg.g-1 for As and Ca respectively. The results indicated that the concentration of As and Ca in the industrial incinerator fly ashes are higher compared to the concentration of the same elements in the two power plants. The variations of elemental existence and concentration in the industrial incinerator and power plant fly ashes samples depend on the differences in compositions and characteristics of the feed sources and combustion temperature.

 

Keywords: trace elements, power plant and industrial incinerator fly ashes, INAA

 

References

1.       Literature review of fly ash. 2003. University of Pretoria etd- Landman, A A.

2.       Goodarzi F. 2006. Characteristics and composition of fly ash form Canadian coal- fired power plants. Fuel 85: 1418-1427.

3.       Hwang H. & Ro C. 2006. Single- particle characterization of municipal solid waste (MSW) ash particles using low-Z particle electron probe X-ray microanalysis. Atmospheric Environment 40: 2873-2881.

4.       Goodarzi F. 2005. Assessment of elements content of milled coal, combustion residues, and stack emitted materials: Possible environmental effects for a Canadian pulverized coal-fired power plant. International Journal of Coal Geology 65: 17-25.

5.       Marrero J., Polla G., Rebagliati R. J., Pla R., Gomez D. & Smichowski P. 2007. Characterization and determination of 28 elements in fly ashes collected in thermal power plant in Argentina using different instrumental techniques. Spectrochimica Acta Part B 62: 101-108

6.       Fardy J. J., McOrist G. D. & FarrarY.J. 1989. Neutron activation analysis and radioactivity measurements of Australian coals and fly ashes. Journal of Radioanalytical and Nuclear Chemistry 133(2): 217-226.

7.       Orvini E. & Pirico R. 1995. Mass Balance Evaluation in Power Plants Using Neutron Activation Analysis. Microchemical Journal 51: 159-165.

8.       Steinnes E. & Rowe  J. J. 1976. Instrumental activation analysis of coal and fly ash with thermal and epithermal neutrons and short-lived nuclides. Analytica Chimica Acta 87: 451-462.

9.       Spears D. A. & Martinez-Tarrazona M. R. 2004. Trace elements in combustion residues from a UK power station. Fuel 83: 2265-2270.

10.    Rowe J. J. & Steinnes E. 1977. Determination of 30 elements in coal and fly ash by thermal and epithermal neutron activation analysis. Talanta 24: 433-439.

11.    Duong P., Thanh V., Dien P. & Binh N. 1995. Application of nuclear activation analysis (NAA) and low-level gamma counting to determine the radionuclide and trace element-pollutant releases from coal-fired power plants in Vietnam. The Science of the total Environment 173/174: 339-344.

12.    White S. C. & Case E. D. 1990. Characterization of fly ash from coal-fired power plants. Journal of Materials Science 25: 5215-5219

 




Previous                    Content                    Next